REMOVING OBJECT

   STEP ONE

  In this picture I will remove the heads of these three peoples. The first step is to duplicate the background layer (short key CTRL+J). Make sure that the background copy layer is selected. Select the clone stamp tool with a hard brush of radius 9 and if you require to increase or decrease the size of the brush then use [for decreasing size and] for increasing size.

  STEP TWO

  Select the pattern from above (circle) to the head for that press ALT+Click and then click on the head to remove it (use alt which is on the left side of the key board). It will become as such.

  STEP THREE

 Duplicate the second layer (CTRL+J) Make sure that the third layer is selected. In the same way select pattern of  coat (circle) for that press Alt+click to select the pattern and then click on the remaining head to remove it same as in the figure.

  STEP FOUR

  Duplicate the third layer then in the same way select the pattern of the coat from circle shown in the figure and then using clone stamp  tool press ALT+Click to select a pattern and then click on the hairs of the lady to remove them as in figure.

  STEP FIVE    

  Now duplicate the forth layer (CTRL+J) and select clone stamp tool and press ALT+Click to select a pattern from the place as shown in the figure (circle) and then click on the remaining hairs to remove them

  STEP SIX

  Duplicate the fifth layer (CTRL+J) then again select the clone stamp tool and press ALT+Click  to select the pattern from the circle shown in the figure and click on the head and remove it as shown in the figure.

  STEP SEVEN

  Duplicate the six layers and select the clone stamp tool then select the pattern from the place as shown in the figure (circle) and then press Alt+ Click to select it then click on the remaining head to remove it.

  STEP EIGHT

  Duplicate the seven layer (CTRL+J) and then correct the arm and shoulders using clone stamp tool.

  FINAL RESULTS